Portable wifi data collection#
This document is Air780E ESP32S3 to do portable wifi related information
Mainly with Air780E, you can actually use EC618 series of other modules, such as Air700E,Air780EG and so on
The speed is not fast, it can be said that it is still relatively slow. As a wifi-to -4G platform, there is a certain load, but donโt consider just being a hot spot for mobile phones..
wifi The account password is
luatos12345678or12341234The management interface account password is
luatos12345678or12341234ESP32S3 Brush is the firmware of the ESP-Iot project, non-LuatOS firmware, if you need to open the development, is to use the esp-idf to use the C language programming.
Firmware and Brush Steps#
Firmware Download: ESP32S3 MIFI Demo Firmware
Brush machine instructions:
Air780E Only AT firmware is required, and the factory default is AT firmware, so there is no need to brush the machine under normal circumstances.
ESP32S3 Brush the firmware in the above link
After the brushing machine is completed, there is a yellow toggle switch on the ESP32S3 development board, tear off the protective film, and toggle to the USB side
Connect the two development boards with a Type-C-to-Type-C line.
Use additional Dupont cable to supply Air780E or ESP32S3 5V/GND
Air780E Remember to insert the card, the corresponding wifi network will be activated after the Air780E is connected to the Internet, and it can be searched.
Air780E You need to press the pwrkey key for 2 seconds to turn on the machine. You can short-circuit the pad next to the pwrkey button to turn on the machine..
FAQ#
ESP32S3 source code of firmware
wifi Canโt find, how to do
The high probability is that the Air780E is not connected to the Internet or the card is not plugged in. Plug the Air780E development board directly into the computer to see if the RNDIS network card appears. If not, you need to brush the AT firmware.